How Wabash County stands out in Illinois
- Small by area: 223 square miles of land, the 5th smallest of the 102 Illinois counties on this site.
- One of the less populous counties we cover in Illinois, with about 11,119 residents (17th smallest of 102).
- Lower-priced homes: a median owner-occupied value of $104,900, 20th lowest among 102 Illinois counties here.
Closest look-alike: Richland County next door. Compared with it, Wabash County has fewer people estimated on high-arsenic wells (24 vs 52) and wells about 62 ft deeper at the median.
Closest match further away: McDonough County elsewhere in Illinois. Next to it, Wabash County has fewer people estimated on high-arsenic wells (24 vs 628) and homes 5 years newer by median year built.
Wells in Wabash County run deeper than most of Illinois
| Household well records | 508 |
|---|---|
| Median depth | 240 ft |
| Middle half of wells | 143 ft to 300 ft |
| Shallowest 10% / deepest 10% | under 90 ft / over 323 ft |
| Median tested yield | 10 gpm |
| Rank in Illinois (deepest = 1) | 8th of 102 |
| Deeper than this share of US counties in our data | 79% |
Most wells with a recorded depth fall 100 to 300 ft (62%).
The median tested yield is 10 gallons per minute.
Wabash County has deeper wells than every neighbour
None of its 6 neighbours with records has a deeper median well. The neighbours range from Edwards County (53 ft) to Richland County (178 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Wabash County | 240 ft | no data | 10 gpm | 24 |
| Richland County | 178 ft | no data | 10 gpm | 52 |
| White County | 175 ft | no data | 10 gpm | 31 |
| Lawrence County | 130 ft | no data | 14 gpm | 67 |
| Knox County, IN | 84 ft | 12 ft | 10 gpm | 79 |
| Gibson County, IN | 75 ft | 7 ft | 10 gpm | 87 |
| Edwards County | 53 ft | no data | 8 gpm | 2 |
Neighbours: Census county adjacency 2024.
Drilling a 240 ft well in Wabash County
Half of all wells here go past 200 ft, so expect a bigger drilling bill: 240 ft at $25 to $65 a foot (Angi 2026 cost guide) is about $6,000 to $15,600.
Against a median home value of $104,900 (Census ACS 2020–2024), a new well at that depth is about 6% to 15% of a house's worth, before equipment.
Equipment and permits come on top; our guide to drilling quotes shows what to ask Illinois drillers to itemize.
Water quality in Wabash County
Wabash County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.
Arsenic estimate
The USGS arsenic model puts about 24 Wabash County residents (range 19 to 31) on household wells above 10 µg/L, lower than most Illinois counties. That is more than in about 17% of Illinois counties. USGS model estimate.
What to test for in Wabash County
- Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
- Arsenic at least once; the county estimate is low, but single wells vary.
What lies beneath Wabash County
Most of Wabash County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
Buying an older home with a well in Wabash County
- The median home in Wabash County was built in 1970. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
- A well between 143 ft and 300 ft is normal for Wabash County. Much shallower than 143 ft deserves a careful water test.
- Ask for a flow or yield test and compare it with the county median of 10 gallons per minute.
- Book a well inspection as well as a water test; they check different things.
Drilling over the decades in Wabash County
The 1980s were the busiest decade, with 151 new household wells on record. Only 0% of dated records are from 2010 or later, so most wells in service are older.
Help in Illinois
For Wabash County well owners: Illinois Department of Public Health, Toxicology / Environmental Health, certified labs in Illinois, free or low-cost testing, and all Illinois well rules and data.
Questions about wells in Wabash County
What is the average well depth in Wabash County, Illinois?
240 ft is the median across 508 household well records; the middle half are 143 ft to 300 ft.
Are wells in Wabash County deeper than elsewhere in Illinois?
Yes: Wabash County ranks deeper than about 92% of Illinois counties in our data, and deeper than 79% of US counties we cover.
What would a new well in Wabash County cost to drill?
Roughly $6,000 to $15,600 for the drilling at the median depth of 240 ft, before the pump and pressure tank.
How old are homes in Wabash County?
The Census median year built for Wabash County homes is 1970; it covers all homes, not only those on wells.
Data for Wabash County
508 household well records, dated from the 1970s to the 2000s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Wabash County as JSON (CC BY 4.0).
