How Washington County stands out in Illinois
- One of the most varied well-depth patterns in Illinois: the middle half spans 29 ft to 110 ft.
- A high share of owner-occupied homes (84%), 8th highest in our Illinois set.
- Very little surface water: lakes and rivers cover under 1% of the county, one of the lowest shares in Illinois.
Closest look-alike: Marion County next door. Compared with it, Washington County has more people estimated on high-arsenic wells (60 vs 15) and median home values $52,700 higher.
Closest match further away: Morgan County elsewhere in Illinois. Next to it, Washington County has fewer people estimated on high-arsenic wells (60 vs 232), homes 7 years newer by median year built and median home values $24,900 higher.
Shallow wells in Washington County
| Household well records | 610 |
|---|---|
| Median depth | 40 ft |
| Middle half of wells | 29 ft to 110 ft |
| Shallowest 10% / deepest 10% | under 23 ft / over 205 ft |
| Median tested yield | 9 gpm |
| Rank in Illinois (deepest = 1) | 93rd of 102 |
| Deeper than this share of US counties in our data | 1% |
Most wells with a recorded depth fall under 100 ft (69%).
The median tested yield is 9 gallons per minute. See options for low-yield wells.
A 40 ft well is cheap to drill
Shallow wells keep drilling costs down. At $25 to $65 a foot (Angi 2026 cost guide), reaching Washington County's median of 40 ft costs about $1,000 to $2,600 for the hole itself.
That is small next to local house prices: under 2% of the median home value of $155,700 (Census ACS 2020–2024).
Shallow wells sit closer to surface water and septic systems, so bacteria and nitrate tests matter more here.
Water quality in Washington County
Washington County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.
Arsenic estimate
The USGS arsenic model puts about 60 Washington County residents (range 46 to 77) on household wells above 10 µg/L, lower than most Illinois counties. That is more than in about 31% of Illinois counties. USGS model estimate.
What to test for in Washington County
- Coliform bacteria and nitrate every year. With wells this shallow, these matter most.
- Arsenic at least once; the county estimate is low, but single wells vary.
What lies beneath Washington County
Most of Washington County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
Buying a home with a well in Washington County
- The median home here was built in 1972. Ask the seller for the well log, or look it up in the state well records.
- Most wells here are between 29 ft and 110 ft. A shallow well near a septic field or barnyard needs a bacteria test before closing.
- Insist on a flow test: yields are low here (median 9 gallons per minute), and a low-yield well may need a storage tank.
- Book a well inspection as well as a water test; they check different things.
Drilling over the decades in Washington County
Drilling peaked early, in the 1970s, when 277 household wells were logged. Only 0% of dated records are from 2010 or later, so most wells in service are older.
Washington County next to its neighbours
3 of 6 neighbouring counties with records drill deeper. Medians nearby run from Clinton County (35 ft) to St. Clair County (85 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Washington County | 40 ft | no data | 9 gpm | 60 |
| St. Clair County | 85 ft | no data | 15 gpm | 937 |
| Jefferson County | 55 ft | no data | 8 gpm | 27 |
| Randolph County | 55 ft | no data | 15 gpm | 68 |
| Marion County | 40 ft | no data | 8 gpm | 15 |
| Perry County | 38 ft | no data | 12 gpm | 38 |
| Clinton County | 35 ft | no data | 15 gpm | 96 |
Neighbours: Census county adjacency 2024.
Help in Illinois
For Washington County well owners: Illinois Department of Public Health, Toxicology / Environmental Health, certified labs in Illinois, free or low-cost testing, and all Illinois well rules and data.
Questions about wells in Washington County
How deep are wells in Washington County, Illinois?
The median is 40 ft across 610 records, but depths vary a lot: the middle half run from 29 ft to 110 ft.
Are wells in Washington County deeper than elsewhere in Illinois?
No, they are shallower: Washington County ranks deeper than about 9% of Illinois counties in our data, and deeper than 1% of US counties we cover.
How much water does a Washington County well produce?
The median tested yield is 9 gallons per minute.
What would a new well in Washington County cost to drill?
Roughly $1,000 to $2,600 for the drilling at the median depth of 40 ft, one of the cheaper drilling bills because wells here are shallow.
Data for Washington County
610 household well records, dated from the 1960s to the 1990s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Washington County as JSON (CC BY 4.0).
