How Pike County stands out in Indiana
- A high share of owner-occupied homes (87%), 1st highest in our Indiana set.
- One of the less populous counties we cover in Indiana, with about 12,154 residents (8th smallest of 91).
- A thin driller archive: 220 household well records, 11th fewest of 91 Indiana counties.
- Wells are spread thin: 66 household well records per 100 square miles, 11th sparsest in Indiana.
Closest look-alike: Warrick County next door. Compared with it, Pike County has fewer people estimated on high-arsenic wells (13 vs 38), homes 13 years older by median year built and median home values $87,600 lower.
Closest match further away: Sullivan County elsewhere in Indiana. Next to it, Pike County has fewer people estimated on high-arsenic wells (13 vs 74), median home values $23,800 higher and wells about 12 ft shallower at the median.
Wells in Pike County run deeper than most of Indiana
| Household well records | 220 |
|---|---|
| Median depth | 125 ft |
| Middle half of wells | 80 ft to 184 ft |
| Shallowest 10% / deepest 10% | under 50 ft / over 225 ft |
| Median tested yield | 6 gpm |
| Rank in Indiana (deepest = 1) | 16th of 91 |
| Deeper than this share of US counties in our data | 40% |
Most wells with a recorded depth fall 100 to 300 ft (66%). Only 0% reach 500 ft or more.
Yields are weak by Indiana standards: the median tested well gives 6 gallons per minute, less than in about 88% of counties in our state data. See options for low-yield wells.
What drilling to 125 ft costs in Pike County
Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 125 ft runs about $3,100 to $8,100.
Against a median home value of $154,900 (Census ACS 2020–2024), a new well at that depth is about 2% to 5% of a house's worth, before equipment.
Equipment and permits come on top; our guide to drilling quotes shows what to ask Indiana drillers to itemize.
Water quality in Pike County
Pike County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.
Arsenic estimate
The USGS arsenic model puts about 13 Pike County residents (range 10 to 16) on household wells above 10 µg/L, lower than most Indiana counties. That is more than in about 10% of Indiana counties. USGS model estimate.
What to test for in Pike County
- Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
- Arsenic at least once; the county estimate is low, but single wells vary.
What lies beneath Pike County
Most of Pike County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
Pike County next to its neighbours
Only 2 of 5 neighbouring counties with records have a deeper median well; nearby medians span from Gibson County (75 ft) to Daviess County (220 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Pike County | 125 ft | no data | 6 gpm | 13 |
| Daviess County | 220 ft | no data | 15 gpm | 214 |
| Dubois County | 177 ft | no data | 9 gpm | 17 |
| Warrick County | 89 ft | no data | 5 gpm | 38 |
| Knox County | 84 ft | 12 ft | 10 gpm | 79 |
| Gibson County | 75 ft | 7 ft | 10 gpm | 87 |
Neighbours: Census county adjacency 2024.
Drilling over the decades in Pike County
The 1980s were the busiest decade, with 61 new household wells on record. Only 0% of dated records are from 2010 or later, so most wells in service are older.
Buying a home with a well in Pike County
- The median home here was built in 1973. Ask the seller for the well log, or look it up in the state well records.
- A well between 80 ft and 184 ft is normal for Pike County. Much shallower than 80 ft deserves a careful water test.
- Insist on a flow test: yields are low here (median 6 gallons per minute), and a low-yield well may need a storage tank.
- 87% of occupied homes in Pike County are owner-occupied (Census ACS 2020–2024). That is high, so sellers here have usually lived with the well and can tell you its history.
Help in Indiana
For Pike County well owners: Purdue University Extension, free or low-cost testing, and all Indiana well rules and data.
Questions about wells in Pike County
What is the average well depth in Pike County, Indiana?
125 ft is the median across 220 household well records; the middle half are 80 ft to 184 ft.
How much water does a Pike County well produce?
The median tested yield is 6 gallons per minute, low for the state.
Are wells in Pike County deeper than elsewhere in Indiana?
Yes: Pike County ranks deeper than about 82% of Indiana counties in our data, and deeper than 40% of US counties we cover.
What would a new well in Pike County cost to drill?
Roughly $3,100 to $8,100 for the drilling at the median depth of 125 ft, before the pump and pressure tank.
Data for Pike County
220 household well records, dated from the 1980s to the 2000s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Pike County as JSON (CC BY 4.0).
