Ask a question
103 ftmedian well depth35th deepest of 91 in IN
234household well recordsState well records
22 ftmedian water levelDriller-reported
10 gpmmedian tested yieldDriller-reported
At a glanceThe figures come from 234 household well records, a smaller sample than most, so read them as a rough guide. About 54% of Washington County is over the Mississippian aquifers (sandstone and carbonate-rock aquifers), with 46% over rock outside any principal aquifer. Half of the wells are between 80 ft and 145 ft deep. Washington County has about 28,212 residents on 514 square miles. Its 46 household well records per 100 square miles are among the sparsest in the state. It borders Clark, Crawford, Floyd, Harrison, Jackson, Lawrence, Orange and Scott counties. It lies in southern Indiana.

How Washington County stands out in Indiana

  • Large by area: 514 square miles of land, the 7th largest of the 91 Indiana counties on this site.
  • Wells are spread thin: 46 household well records per 100 square miles, 8th sparsest in Indiana.
  • A thin driller archive: 234 household well records, 13th fewest of 91 Indiana counties.
  • Newer housing than most of Indiana: the median home was built in 1982, the 14th newest of 91 counties.

Closest look-alike: Clark County next door. Compared with it, Washington County has more people estimated on high-arsenic wells (67 vs 15), wells about 31 ft deeper at the median and median home values $50,700 lower.

Closest match further away: Putnam County elsewhere in Indiana. Next to it, Washington County has fewer people estimated on high-arsenic wells (67 vs 298), median home values $46,700 lower and wells about 2 ft deeper at the median.

How deep wells go in Washington County

groundmiddle half of wells: 80 ft–145 ftwater level 22 ftmedian well 103 ftdeepest 10% start at 189 ft
To scale: ground, the median water level at 22 ft and the median well bottom at 103 ft in Washington County.
Household well records234
Median depth103 ft
Middle half of wells80 ft to 145 ft
Shallowest 10% / deepest 10%under 60 ft / over 189 ft
Median static water level22 ft
Median tested yield10 gpm
Rank in Indiana (deepest = 1)35th of 91
Deeper than this share of US counties in our data28%

Most wells with a recorded depth fall 100 to 300 ft (58%). Only 2% reach 500 ft or more.

Between the median water level and the median depth sit about 80 ft of water, roughly 118 gallons in a 6-inch casing.

The median tested yield is 10 gallons per minute.

Washington County and the Mississippian aquifers

About 54% of Washington County is over the Mississippian aquifers (sandstone and carbonate-rock aquifers), with 46% over rock outside any principal aquifer. Among the 87 counties in our data that sit mainly over the same aquifer (across 8 states), Washington County's median well of 103 ft is near the middle: deeper than about 41% of them.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

What drilling to 103 ft costs in Washington County

Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 103 ft runs about $2,600 to $6,700.

That is small next to local house prices: under 4% of the median home value of $172,200 (Census ACS 2020–2024).

With a typical water level of 22 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

Water quality in Washington County

Washington County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.

Arsenic estimate

The USGS arsenic model puts about 67 Washington County residents (range 53 to 85) on household wells above 10 µg/L, lower than most Indiana counties. That is more than in about 21% of Indiana counties. USGS model estimate.

What to test for in Washington County

  • Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
  • Arsenic at least once; the county estimate is low, but single wells vary.

Drilling over the decades in Washington County

Drilling peaked early, in the 1960s, when 107 household wells were logged. Only 0% of dated records are from 2010 or later, so most wells in service are older.

Buying a home with a well in Washington County

  • The median home here was built in 1982. Ask the seller for the well log, or look it up in the state well records.
  • A well between 80 ft and 145 ft is normal for Washington County. Much shallower than 80 ft deserves a careful water test.
  • Ask for a flow or yield test and compare it with the county median of 10 gallons per minute.
  • Book a well inspection as well as a water test; they check different things.

Washington County next to its neighbours

Clark County: median depth 72 ftCrawford County: median depth 166 ftFloyd County: median depth 96 ftHarrison County: median depth 120 ftJackson County: median depth 50 ftLawrence County: median depth 140 ftOrange County: median depth 170 ftScott County: median depth 36 ftWashington County: median depth 103 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
Washington County (orange outline) with 8 neighbouring counties; darker means deeper median wells.

4 of 8 neighbouring counties with records drill deeper. Medians nearby run from Scott County (36 ft) to Orange County (170 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
Washington County103 ft22 ft10 gpm67
Orange County170 ft40 ft10 gpm51
Crawford County166 ft40 ft10 gpm7
Lawrence County140 ft40 ft4 gpm16
Harrison County120 ft55 ft10 gpm20
Floyd County96 ft23 ft2 gpm3
Clark County72 ft20 ft10 gpm15
Jackson County50 ft15 ft16 gpm348
Scott County36 ft4 ft5 gpm10

Neighbours: Census county adjacency 2024.

Help in Indiana

For Washington County well owners: Purdue University Extension, free or low-cost testing, and all Indiana well rules and data.

Questions about wells in Washington County

What is the average well depth in Washington County, Indiana?

103 ft is the median across 234 household well records; the middle half are 80 ft to 145 ft.

What would a new well in Washington County cost to drill?

Roughly $2,600 to $6,700 for the drilling at the median depth of 103 ft, before the pump and pressure tank.

What aquifer do wells in Washington County draw from?

About 54% of Washington County is over the Mississippian aquifers (sandstone and carbonate-rock aquifers), with 46% over rock outside any principal aquifer. Your own well log names the formation your well actually taps.

Is well water safe to drink in Washington County?

Only a certified lab test of your own well can say.

How much water does a Washington County well produce?

The median tested yield is 10 gallons per minute.

Data for Washington County

234 household well records, dated from the 1960s to the 1970s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Washington County as JSON (CC BY 4.0).

Questions about a well in Washington County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program