How Lincoln County stands out in Kansas
- Older housing than most of Kansas: the median home was built in 1938, the oldest of the 105 counties we cover.
- A high share of owner-occupied homes (80%), 18th highest in our Kansas set.
- One of the most varied well-depth patterns in Kansas: the middle half spans 70 ft to 170 ft.
Closest look-alike: Ellsworth County next door. Compared with it, Lincoln County has homes 20 years older by median year built, higher yields (20 vs 15 gpm) and median home values $18,000 lower.
Closest match further away: Hodgeman County elsewhere in Kansas. Next to it, Lincoln County has fewer people estimated on high-arsenic wells (4 vs 27), homes 19 years older by median year built and water standing 5 ft closer to the surface.
Wells in Lincoln County run deeper than most of Kansas
| Household well records | 812 |
|---|---|
| Median depth | 110 ft |
| Middle half of wells | 70 ft to 170 ft |
| Shallowest 10% / deepest 10% | under 50 ft / over 231 ft |
| Median static water level | 55 ft |
| Median tested yield | 20 gpm |
| Rank in Kansas (deepest = 1) | 29th of 105 |
| Deeper than this share of US counties in our data | 32% |
Most wells with a recorded depth fall 100 to 300 ft (56%).
Between the median water level and the median depth sit about 55 ft of water, roughly 81 gallons in a 6-inch casing.
The median tested yield is 20 gallons per minute.
Lincoln County has deeper wells than every neighbour
None of its 6 neighbours with records has a deeper median well. The neighbours range from Mitchell County (50 ft) to Ellsworth County (98 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Lincoln County | 110 ft | 55 ft | 20 gpm | 4 |
| Ellsworth County | 98 ft | 50 ft | 15 gpm | 5 |
| Russell County | 80 ft | 40 ft | 12 gpm | near 0 |
| Ottawa County | 77 ft | 32 ft | 20 gpm | 15 |
| Saline County | 54 ft | 21 ft | 30 gpm | 17 |
| Mitchell County | 50 ft | 30 ft | 15 gpm | near 0 |
| Osborne County | 50 ft | 25 ft | 20 gpm | 2 |
Neighbours: Census county adjacency 2024.
Buying an older home with a well in Lincoln County
- The median home in Lincoln County was built in 1938. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
- A well between 70 ft and 170 ft is normal for Lincoln County. Much shallower than 70 ft deserves a careful water test.
- A flow test should be routine; county wells are productive, with a median of 20 gallons per minute.
- Book a well inspection as well as a water test; they check different things.
Lincoln County and the Lower Cretaceous aquifers
About 57% of Lincoln County is over the Lower Cretaceous aquifers (sandstone aquifers), with 43% over rock outside any principal aquifer. Among the 47 counties in our data that sit mainly over the same aquifer (across 5 states), Lincoln County's median well of 110 ft is shallower than most: deeper than about 30% of them.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
What drilling to 110 ft costs in Lincoln County
Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 110 ft runs about $2,800 to $7,200. At the 75th percentile (170 ft) it is $4,200 to $11,000.
Against a median home value of $96,900 (Census ACS 2020–2024), a new well at that depth is about 3% to 7% of a house's worth, before equipment.
With a typical water level of 55 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.
Drilling over the decades in Lincoln County
Wells completed since 2010 are somewhat deeper (median 130 ft) than those drilled before 1990 (110 ft). Much of the drilling is recent: the busiest decade was the 2000s, with 203 household wells logged.
Water quality in Lincoln County
Lincoln County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.
Arsenic estimate
The USGS arsenic model puts about 4 Lincoln County residents (range 4 to 5) on household wells above 10 µg/L, lower than most Kansas counties. That is more than in about 30% of Kansas counties. USGS model estimate.
What to test for in Lincoln County
- Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
- Arsenic at least once; the county estimate is low, but single wells vary.
Help in Kansas
For Lincoln County well owners: Kansas Geological Survey (University of Kansas), free or low-cost testing, and all Kansas well rules and data.
Questions about wells in Lincoln County
What is the average well depth in Lincoln County, Kansas?
110 ft is the median across 812 household well records; the middle half are 70 ft to 170 ft.
How old are homes in Lincoln County?
The Census median year built for Lincoln County homes is 1938; it covers all homes, not only those on wells.
What aquifer do wells in Lincoln County draw from?
About 57% of Lincoln County is over the Lower Cretaceous aquifers (sandstone aquifers), with 43% over rock outside any principal aquifer. Your own well log names the formation your well actually taps.
How far down is the water in Lincoln County wells?
Driller logs put the median static water level at 55 ft below ground.
How much water does a Lincoln County well produce?
The median tested yield is 20 gallons per minute.
Data for Lincoln County
812 household well records, dated from the 1970s to the 2020s, from Kansas Geological Survey WWC5 water well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Lincoln County as JSON (CC BY 4.0).
