How Washington County stands out in Kansas
- Older housing than most of Kansas: the median home was built in 1953, the 15th oldest of 105 counties.
- A high share of owner-occupied homes (78%), 29th highest in our Kansas set.
- Large by area: 895 square miles of land, the 30th largest of the 105 Kansas counties on this site.
Closest look-alike: Riley County next door. Compared with it, Washington County has homes 31 years older by median year built, median home values $120,000 lower and higher yields (25 vs 20 gpm).
Closest match further away: Comanche County elsewhere in Kansas. Next to it, Washington County has median home values $47,500 higher, higher yields (25 vs 20 gpm) and homes 6 years newer by median year built.
Washington County and the Lower Cretaceous aquifers
About 64% of Washington County is over the Lower Cretaceous aquifers (sandstone aquifers), with 36% over rock outside any principal aquifer. Among the 47 counties in our data that sit mainly over the same aquifer (across 5 states), Washington County's median well of 89 ft is shallower than most: deeper than about 11% of them.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
How deep wells go in Washington County
| Household well records | 1,040 |
|---|---|
| Median depth | 89 ft |
| Middle half of wells | 58 ft to 120 ft |
| Shallowest 10% / deepest 10% | under 40 ft / over 166 ft |
| Median static water level | 41 ft |
| Median tested yield | 25 gpm |
| Rank in Kansas (deepest = 1) | 49th of 105 |
| Deeper than this share of US counties in our data | 19% |
Most wells with a recorded depth fall under 100 ft (58%).
Between the median water level and the median depth sit about 48 ft of water, roughly 71 gallons in a 6-inch casing.
Wells here are productive, with a median tested yield of 25 gallons per minute, more than in about 82% of Kansas counties.
Buying an older home with a well in Washington County
- The median home in Washington County was built in 1953. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
- A well between 58 ft and 120 ft is normal for Washington County. Much shallower than 58 ft deserves a careful water test.
- A flow test should be routine; county wells are productive, with a median of 25 gallons per minute.
- Book a well inspection as well as a water test; they check different things.
A 89 ft well is cheap to drill
Shallow wells keep drilling costs down. At $25 to $65 a foot (Angi 2026 cost guide), reaching Washington County's median of 89 ft costs about $2,200 to $5,800 for the hole itself.
That is small next to local house prices: under 5% of the median home value of $117,100 (Census ACS 2020–2024).
With a typical water level of 41 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.
Washington County next to its neighbours
6 of 8 neighbouring counties with records drill deeper. Medians nearby run from Republic County (64 ft) to Jefferson County (140 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Washington County | 89 ft | 41 ft | 25 gpm | 7 |
| Jefferson County, NE | 140 ft | 78 ft | 14 gpm | 16 |
| Thayer County, NE | 130 ft | 80 ft | 12 gpm | 10 |
| Cloud County | 106 ft | 46 ft | 22 gpm | 26 |
| Gage County, NE | 103 ft | 55 ft | 15 gpm | 122 |
| Clay County | 96 ft | 45 ft | 20 gpm | 13 |
| Riley County | 90 ft | 40 ft | 20 gpm | 13 |
| Marshall County | 74 ft | 35 ft | 15 gpm | 10 |
| Republic County | 64 ft | 30 ft | 15 gpm | 5 |
Neighbours: Census county adjacency 2024.
Water quality in Washington County
Washington County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.
Arsenic estimate
The USGS arsenic model puts about 7 Washington County residents (range 6 to 9) on household wells above 10 µg/L, lower than most Kansas counties. That is more than in about 33% of Kansas counties. USGS model estimate.
What to test for in Washington County
- Coliform bacteria and nitrate every year; 58% of wells here are under 100 ft deep.
- Arsenic at least once; the county estimate is low, but single wells vary.
Drilling over the decades in Washington County
Depths have barely changed over time: 98 ft for wells before 1990 and 97 ft since 2010. Much of the drilling is recent: the busiest decade was the 2000s, with 258 household wells logged.
Help in Kansas
For Washington County well owners: Kansas Geological Survey (University of Kansas), free or low-cost testing, and all Kansas well rules and data.
Questions about wells in Washington County
How deep are wells in Washington County, Kansas?
89 ft is the median across 1,040 household well records; the middle half are 58 ft to 120 ft.
How old are homes in Washington County?
The Census median year built for Washington County homes is 1953; it covers all homes, not only those on wells.
What aquifer do wells in Washington County draw from?
About 64% of Washington County is over the Lower Cretaceous aquifers (sandstone aquifers), with 36% over rock outside any principal aquifer. Your own well log names the formation your well actually taps.
How much water does a Washington County well produce?
The median tested yield is 25 gallons per minute, high for the state.
How far down is the water in Washington County wells?
Driller logs put the median static water level at 41 ft below ground.
Data for Washington County
1,040 household well records, dated from the 1970s to the 2020s, from Kansas Geological Survey WWC5 water well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Washington County as JSON (CC BY 4.0).
