How Shiawassee County stands out in Michigan
- Very little surface water: lakes and rivers cover 2% of the county, one of the lowest shares in Michigan.
- Older housing than most of Michigan: the median home was built in 1969, the 19th oldest of 83 counties.
- Small by area: 531 square miles of land, the 19th smallest of the 83 Michigan counties on this site.
Closest look-alike: Ingham County next door. Compared with it, Shiawassee County has more people estimated on high-arsenic wells (4,393 vs 1,922), lower yields (20 vs 30 gpm) and median home values $27,200 lower.
Closest match further away: Huron County elsewhere in Michigan. Next to it, Shiawassee County has more people estimated on high-arsenic wells (4,393 vs 3,924), median home values $17,300 higher and wells about 10 ft deeper at the median.
Wells in Shiawassee County run deeper than most of Michigan
| Household well records | 14,014 |
|---|---|
| Median depth | 140 ft |
| Middle half of wells | 77 ft to 182 ft |
| Shallowest 10% / deepest 10% | under 49 ft / over 230 ft |
| Median static water level | 20 ft |
| Median tested yield | 20 gpm |
| Rank in Michigan (deepest = 1) | 7th of 83 |
| Deeper than this share of US counties in our data | 47% |
Most wells with a recorded depth fall 100 to 300 ft (66%).
Between the median water level and the median depth sit about 120 ft of water, roughly 176 gallons in a 6-inch casing.
The median tested yield is 20 gallons per minute.
Arsenic in Shiawassee County wells
Public sampling data for Shiawassee County is thin (fewer than 10 wells with recent results), so the arsenic model below is the best county-level guide.
Arsenic estimate
Arsenic is a bigger issue than in most of Michigan: USGS estimates about 4,393 people here (range 3,657 to 5,254) use household wells above 10 µg/L. USGS model estimate.
What to test for in Shiawassee County
- Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
- Arsenic: USGS estimates about 4,393 people here drink from household wells above the 10 µg/L limit.
Shiawassee County and the Pennsylvanian aquifers
All or nearly all of Shiawassee County sits over the Pennsylvanian aquifers (sandstone aquifers), the uppermost principal aquifer USGS maps here. Among the 97 counties in our data that sit mainly over the same aquifer (across 5 states), Shiawassee County's median well of 140 ft is deeper than most: deeper than about 76% of them.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
What drilling to 140 ft costs in Shiawassee County
Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 140 ft runs about $3,500 to $9,100.
Against a median home value of $171,600 (Census ACS 2020–2024), a new well at that depth is about 2% to 5% of a house's worth, before equipment.
With water only 20 ft down, some homes can use a shallow-well jet pump, which lifts water about 25 feet at most; the rest need a submersible. See pump sizing.
Buying an older home with a well in Shiawassee County
- The median home in Shiawassee County was built in 1969. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
- A well between 77 ft and 182 ft is normal for Shiawassee County. Much shallower than 77 ft deserves a careful water test.
- Ask for a flow or yield test and compare it with the county median of 20 gallons per minute.
- Book a well inspection as well as a water test; they check different things.
Drilling over the decades in Shiawassee County
Depths have barely changed over time: 142 ft for wells before 1990 and 138 ft since 2010. The 1990s were the busiest decade, with 4,166 new household wells on record. Only 13% of dated records are from 2010 or later, so most wells in service are older.
Shiawassee County next to its neighbours
3 of 6 neighbouring counties with records drill deeper. Medians nearby run from Livingston County (86 ft) to Clinton County (215 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Shiawassee County | 140 ft | 20 ft | 20 gpm | 4,393 |
| Clinton County | 215 ft | 32 ft | 50 gpm | 8,229 |
| Genesee County | 180 ft | 30 ft | 25 gpm | 6,942 |
| Ingham County | 150 ft | 23 ft | 30 gpm | 1,922 |
| Saginaw County | 120 ft | 15 ft | 15 gpm | 4,397 |
| Gratiot County | 108 ft | 19 ft | 40 gpm | 5,767 |
| Livingston County | 86 ft | 25 ft | 25 gpm | 7,681 |
Neighbours: Census county adjacency 2024.
Help in Michigan
For Shiawassee County well owners: Michigan Department of Environment, Great Lakes, and Energy (EGLE), with MDHHS Care for MI Drinking Water, certified labs in Michigan, free or low-cost testing, and all Michigan well rules and data.
Questions about wells in Shiawassee County
What is the average well depth in Shiawassee County, Michigan?
140 ft is the median across 14,014 household well records; the middle half are 77 ft to 182 ft.
Are wells in Shiawassee County deeper than elsewhere in Michigan?
Yes: Shiawassee County ranks deeper than about 92% of Michigan counties in our data, and deeper than 47% of US counties we cover.
What aquifer do wells in Shiawassee County draw from?
All or nearly all of Shiawassee County sits over the Pennsylvanian aquifers (sandstone aquifers), the uppermost principal aquifer USGS maps here. Your own well log names the formation your well actually taps.
Is well water safe to drink in Shiawassee County?
Arsenic is the main known risk, with about 4,393 people estimated on high-arsenic wells. Only a certified lab test of your own well can say.
How far down is the water in Shiawassee County wells?
Driller logs put the median static water level at 20 ft below ground.
Data for Shiawassee County
14,014 household well records, dated from the 1960s to the 2020s, from Michigan EGLE Wellogic water wells (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Shiawassee County as JSON (CC BY 4.0).
