Ask a question
122 ftmedian well depth48th deepest of 87 in MN
289household well recordsState well records
+49%depth change, pre-1990 to 2010+State well records
1956median year homes builtCensus ACS
At a glanceThe figures come from 289 household well records, a smaller sample than most, so read them as a rough guide. New wells are going much deeper: those completed since 2010 have a median of 153 ft, against 103 ft before 1990. The median home was built in 1956, so many wells here are decades old. The median tested yield is 18 gallons per minute. Pipestone County is a rural county of about 9,284 people spread over 465 square miles. Its 62 household well records per 100 square miles are among the sparsest in the state. It borders Lincoln, Lyon, Murray and Rock counties, plus 3 counties in South Dakota. It lies in southwestern Minnesota.

How Pipestone County stands out in Minnesota

  • One of the most varied well-depth patterns in Minnesota: the middle half spans 60 ft to 298 ft.
  • A thin driller archive: 289 household well records, 2nd fewest of 87 Minnesota counties.
  • Older housing than most of Minnesota: the median home was built in 1956, the 3rd oldest of 87 counties.
  • Lower-priced homes: a median owner-occupied value of $140,200, 4th lowest among 87 Minnesota counties here.

Closest look-alike: Minnehaha County, South Dakota next door. Compared with it, Pipestone County has homes 31 years older by median year built, median home values $147,400 lower and wells about 8 ft deeper at the median.

Closest match further away: Lac qui Parle County elsewhere in Minnesota. Next to it, Pipestone County has fewer people estimated on high-arsenic wells (0 vs 387), water standing 11 ft further down and higher yields (18 vs 15 gpm).

How deep wells go in Pipestone County

groundmiddle half of wells: 60 ft–298 ftwater level 45 ftmedian well 122 ftdeepest 10% start at 435 ft
To scale: ground, the median water level at 45 ft and the median well bottom at 122 ft in Pipestone County.
Household well records289
Median depth122 ft
Middle half of wells60 ft to 298 ft
Shallowest 10% / deepest 10%under 40 ft / over 435 ft
Median static water level45 ft
Median tested yield18 gpm
Rank in Minnesota (deepest = 1)48th of 87
Deeper than this share of US counties in our data38%

The largest group of wells with a recorded depth fall under 100 ft (39%).

Between the median water level and the median depth sit about 78 ft of water, roughly 114 gallons in a 6-inch casing.

The median tested yield is 18 gallons per minute. See options for low-yield wells.

New wells in Pipestone County are going deeper

1970s86 ft1990s150 ft2000s203 ft2010s192 ft2020s112 ft

New wells are going much deeper: those completed since 2010 have a median of 153 ft, against 103 ft before 1990. Much of the drilling is recent: the busiest decade was the 2000s, with 55 household wells logged. 40% of dated records are from 2010 or later, a sign of steady new drilling.

Buying an older home with a well in Pipestone County

  • The median home in Pipestone County was built in 1956. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
  • A well between 60 ft and 298 ft is normal for Pipestone County. Much shallower than 60 ft deserves a careful water test.
  • Insist on a flow test: yields are low here (median 18 gallons per minute), and a low-yield well may need a storage tank.
  • Book a well inspection as well as a water test; they check different things.

What drilling to 122 ft costs in Pipestone County

Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 122 ft runs about $3,100 to $8,000. At the 75th percentile (298 ft) it is $7,500 to $19,400.

Against a median home value of $140,200 (Census ACS 2020–2024), a new well at that depth is about 2% to 6% of a house's worth, before equipment.

With a typical water level of 45 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

Water quality in Pipestone County

Pipestone County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.

Arsenic estimate

USGS estimates very few people in Pipestone County on household wells with arsenic above 10 µg/L, but a single well can still test high. USGS model estimate.

What to test for in Pipestone County

  • Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
  • Arsenic at least once; the county estimate is low, but single wells vary.

What lies beneath Pipestone County

Most of Pipestone County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

Pipestone County next to its neighbours

Lincoln County: median depth 150 ftLyon County: median depth 106 ftMurray County: median depth 150 ftRock County: median depth 201 ftBrookings County, SD: median depth 61 ftMinnehaha County, SD: median depth 115 ftMoody County, SD: median depth 32 ftPipestone County: median depth 122 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
Pipestone County (orange outline) with 7 neighbouring counties; darker means deeper median wells.

Only 3 of 7 neighbouring counties with records have a deeper median well; nearby medians span from Moody County (32 ft) to Rock County (201 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
Pipestone County122 ft45 ft18 gpmnear 0
Rock County201 ft48 ft20 gpm56
Lincoln County150 ft66 ft15 gpmnear 0
Murray County150 ft55 ft15 gpm401
Minnehaha County, SD115 ft48 ftno datanear 0
Lyon County106 ft30 ft15 gpm624
Brookings County, SD61 ft14 ftno data9
Moody County, SD32 ft32 ftno data1

Neighbours: Census county adjacency 2024.

Help in Minnesota

For Pipestone County well owners: Minnesota Department of Health, Well Management Section, certified labs in Minnesota, free or low-cost testing, and all Minnesota well rules and data.

Questions about wells in Pipestone County

What is the average well depth in Pipestone County, Minnesota?

The median is 122 ft across 289 records, but depths vary a lot: the middle half run from 60 ft to 298 ft.

Are wells getting deeper in Pipestone County?

New wells are going much deeper: those completed since 2010 have a median of 153 ft, against 103 ft before 1990.

How old are homes in Pipestone County?

The Census median year built for Pipestone County homes is 1956; it covers all homes, not only those on wells.

How much water does a Pipestone County well produce?

The median tested yield is 18 gallons per minute.

Data for Pipestone County

289 household well records, dated from the 1970s to the 2020s, from Minnesota County Well Index (MGS/MDH), non-public-supply wells (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Pipestone County as JSON (CC BY 4.0).

Questions about a well in Pipestone County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program