Ask a question
112 ftmedian well depth26th deepest of 56 in MT
1,844household well recordsState well records
+28%depth change, pre-1990 to 2010+State well records
12 gpmmedian tested yieldDriller-reported
At a glance1,844 household well records feed these figures. Most of Hill County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock. Wells completed since 2010 are somewhat deeper (median 134 ft) than those drilled before 1990 (105 ft). Hill County has about 16,155 residents on 2,899 square miles. It borders Blaine, Chouteau and Liberty counties. It lies in northern Montana.

How Hill County stands out in Montana

  • One of the most uniform well-depth patterns in Montana: the middle half spans 63 ft to 172 ft.
  • Its deepest wells go less far than in most of Montana: the deepest 10% start at 240 ft, 10th shallowest of 56.
  • A low share of owner-occupied homes (66%), 11th lowest in our Montana set.
  • One of the more populous counties we cover in Montana, with about 16,155 residents (12th largest of 56).

Closest look-alike: Blaine County next door. Compared with it, Hill County has fewer people estimated on high-arsenic wells (28 vs 73), wells about 32 ft deeper at the median and median home values $47,100 higher.

Closest match further away: Golden Valley County elsewhere in Montana. Next to it, Hill County has more people estimated on high-arsenic wells (28 vs 19), water standing 7 ft further down and wells about 6 ft deeper at the median.

How deep wells go in Hill County

groundmiddle half of wells: 63 ft–172 ftwater level 38 ftmedian well 112 ftdeepest 10% start at 240 ft
To scale: ground, the median water level at 38 ft and the median well bottom at 112 ft in Hill County.
Household well records1,844
Median depth112 ft
Middle half of wells63 ft to 172 ft
Shallowest 10% / deepest 10%under 40 ft / over 240 ft
Median static water level38 ft
Median tested yield12 gpm
Rank in Montana (deepest = 1)26th of 56
Deeper than this share of US counties in our data33%

Most wells with a recorded depth fall 100 to 300 ft (52%). Only 1% reach 500 ft or more.

Between the median water level and the median depth sit about 74 ft of water, roughly 108 gallons in a 6-inch casing.

The median tested yield is 12 gallons per minute.

New wells in Hill County are going deeper

1950s124 ft1960s75 ft1970s100 ft1980s88 ft1990s114 ft2000s132 ft2010s141 ft2020s119 ft

Wells completed since 2010 are somewhat deeper (median 134 ft) than those drilled before 1990 (105 ft). Drilling peaked early, in the 1970s, when 355 household wells were logged. Only 12% of dated records are from 2010 or later, so most wells in service are older.

What drilling to 112 ft costs in Hill County

Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 112 ft runs about $2,800 to $7,200. At the 75th percentile (172 ft) it is $4,300 to $11,200.

That is small next to local house prices: under 4% of the median home value of $202,600 (Census ACS 2020–2024).

With a typical water level of 38 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

Water quality in Hill County

Hill County has too few sampled wells in the Water Quality Portal (under 10) for a county table, so your own test is the only measure.

Arsenic estimate

The USGS arsenic model puts about 28 Hill County residents (range 24 to 33) on household wells above 10 µg/L, lower than most Montana counties. That is more than in about 21% of Montana counties. USGS model estimate.

What to test for in Hill County

  • Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
  • Arsenic at least once; the county estimate is low, but single wells vary.

What lies beneath Hill County

Most of Hill County (100%) lies outside any USGS principal aquifer, so wells draw on smaller, local water-bearing rock.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

Hill County next to its neighbours

Blaine County: median depth 80 ftChouteau County: median depth 66 ftLiberty County: median depth 150 ftHill County: median depth 112 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
Hill County (orange outline) with 3 neighbouring counties; darker means deeper median wells.

Only 1 of 3 neighbouring counties with records have a deeper median well; nearby medians span from Chouteau County (66 ft) to Liberty County (150 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
Hill County112 ft38 ft12 gpm28
Liberty County150 ft60 ft10 gpm19
Blaine County80 ft32 ft12 gpm73
Chouteau County66 ft24 ft10 gpm70

Neighbours: Census county adjacency 2024.

Buying a home with a well in Hill County

  • The median home here was built in 1971. Ask the seller for the well log, or look it up in the state well records.
  • A well between 63 ft and 172 ft is normal for Hill County. Much shallower than 63 ft deserves a careful water test.
  • Ask for a flow or yield test and compare it with the county median of 12 gallons per minute.
  • Book a well inspection as well as a water test; they check different things.

Help in Montana

For Hill County well owners: Montana State University Extension, Water Quality (Well Educated), free or low-cost testing, and all Montana well rules and data.

Questions about wells in Hill County

What is the average well depth in Hill County, Montana?

112 ft is the median across 1,844 household well records; the middle half are 63 ft to 172 ft.

Are wells getting deeper in Hill County?

Wells completed since 2010 are somewhat deeper (median 134 ft) than those drilled before 1990 (105 ft).

What would a new well in Hill County cost to drill?

Roughly $2,800 to $7,200 for the drilling at the median depth of 112 ft, before the pump and pressure tank.

How much water does a Hill County well produce?

The median tested yield is 12 gallons per minute.

Data for Hill County

1,844 household well records, dated from the 1950s to the 2020s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Hill County as JSON (CC BY 4.0).

Questions about a well in Hill County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program