# Private wells in Adams County, Washington

By Rohit S, Editor and data lead, PrivateWell. Updated 19 November 2026.

## At a glance

Adams County is one of the deepest-well counties in Washington: its median household well goes down 300 ft, deeper than about 100% of the 39 Washington counties in our data. The county has 813 household well records on file, enough for stable medians. Wells here are productive, with a median tested yield of 50 gallons per minute, more than in about 95% of Washington counties. About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Static water levels are among the deeper ones in the state, with a median of 84 ft below ground. Adams County has about 20,800 residents on 1,925 square miles. Its 42 household well records per 100 square miles are among the sparsest in the state. It borders Franklin, Grant, Lincoln and Whitman counties. It lies in eastern Washington.

## Deep wells in Adams County

Household well records 813 Median depth 300 ft Middle half of wells 190 ft to 533 ft Shallowest 10% / deepest 10% under 140 ft / over 1,226 ft Median static water level 84 ft Median tested yield 50 gpm Rank in Washington (deepest = 1) 1st of 39 Deeper than this share of US counties in our data 87% Under 100 ft 3% 100 to 300 ft 44% 300 to 500 ft 26% 500 ft or more 28% The largest group of wells with a recorded depth fall 100 to 300 ft (44%). A typical well here holds a deep column of water, about 216 ft, or 318 gallons in a 6-inch casing. That reserve covers short bursts of heavy use while the aquifer refills the well. Wells here are productive, with a median tested yield of 50 gallons per minute, more than in about 95% of Washington counties.

## Adams County and the Columbia Plateau basin-fill aquifers

About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Among the 6 counties in our data that sit mainly over the same aquifer, Adams County's median well of 300 ft is deeper than most: deeper than about 100% of them. Columbia Plateau basin-fill aquifers 59% Columbia Plateau basaltic-rock aquifers 41% Uppermost principal aquifer: USGS Principal Aquifers map , sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

## Deep wells make drilling in Adams County expensive

At 300 ft for a median well, depth drives the bill: $25 to $65 a foot ( Angi 2026 cost guide ) puts drilling alone at $7,500 to $19,500 . A well as deep as the 75th percentile (533 ft) would be $13,300 to $34,600. Against a median home value of $273,300 (Census ACS 2020–2024), a new well at that depth is about 3% to 7% of a house's worth, before equipment. With a typical water level of 84 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

## Adams County has deeper wells than every neighbour

None of its 4 neighbours with records has a deeper median well. The neighbours range from Grant County (180 ft) to Lincoln County (230 ft). County Median depth Water level Yield People on high-arsenic wells (est.) Adams County 300 ft 84 ft 50 gpm 632 Lincoln County 230 ft 71 ft 28 gpm 163 Whitman County 220 ft 60 ft 50 gpm 186 Franklin County 203 ft 100 ft 112 gpm 3,212 Grant County 180 ft 65 ft 40 gpm 4,097 Neighbours: Census county adjacency 2024.

## Arsenic is the one to test for in Adams County

In measured groundwater samples, arsenic was the most common problem, with 10% of 10 tested wells over the EPA MCL. Substance Wells tested Over limit Median Limit used Years Arsenic 10 10% 3.9 µg/L EPA MCL 2002 to 2023 Nitrate (as N) 12 8% 4.14 mg/L as N EPA MCL 1994 to 2016 Uranium 10 0% 5.895 µg/L EPA MCL 2002 to 2023 Manganese 12 0% 0.0002 mg/L EPA lifetime health advisory 1994 to 2023 Iron 12 0% 0.0045 mg/L EPA SMCL 1994 to 2023 Fluoride 12 0% 0.555 mg/L EPA MCL 1994 to 2023 Lead 10 0% 0.0445 µg/L EPA action level 2002 to 2023 Radon 12 0% 340 pCi/L EPA AMCL 1994 to 2016 Hardness 12 no data 227.5 mg/L as CaCO3 over 180 mg/L is very hard 1994 to 2023 Latest result per well since 1990, Water Quality Portal ; 102 results across 9 substances. Arsenic estimate About 632 people in Adams County (range 524 to 758) are estimated by USGS to be on household wells above the 10 µg/L arsenic limit, a middling figure for Washington. That is more than in about 51% of Washington counties. USGS model estimate . What to test for in Adams County Coliform bacteria and nitrate every year even in wells this deep (300 ft median); bacteria get in through a cracked cap or casing, not only through the aquifer. Arsenic: USGS estimates about 632 people here drink from household wells above the 10 µg/L limit. Hardness if you are thinking about a softener (sampled median 228 mg/L). Got results already? Check them with our result interpreter .

## Drilling over the decades in Adams County

Much of the drilling is recent: the busiest decade was the 2010s, with 242 household wells logged. 49% of dated records are from 2010 or later, a sign of steady new drilling.

## Buying a home with a well in Adams County

The median home here was built in 1977. Ask the seller for the well log, or look it up in Well Construction Reports (Well Log Database), Washington Department of Ecology. Wells here commonly run 190 ft to 533 ft. If the log shows a much shallower well, ask the inspector why. A flow test should be routine; county wells are productive, with a median of 50 gallons per minute. Make sure the water test includes arsenic; 10% of sampled local wells were over its limit.

## Questions

### How deep do you have to drill for water in Adams County, Washington?

The median is 300 ft across 813 records, but depths vary a lot: the middle half run from 190 ft to 533 ft.

### Are wells in Adams County deeper than elsewhere in Washington?

Yes: Adams County ranks deeper than about 100% of Washington counties in our data, and deeper than 87% of US counties we cover.

### What aquifer do wells in Adams County draw from?

About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Your own well log names the formation your well actually taps.

### How much water does a Adams County well produce?

The median tested yield is 50 gallons per minute, high for the state.

### How far down is the water in Adams County wells?

Driller logs put the median static water level at 84 ft below ground.

## Sources

- Well Construction Reports (Well Log Database), Washington Department of Ecology: https://services.arcgis.com/6lCKYNJLvwTXqrmp/arcgis/rest/services/WR/FeatureServer/9
- USGS county arsenic model (Ayotte and others, 2017): https://doi.org/10.5066/F7CN724V
- U.S. Census Bureau, American Community Survey 2020-2024 5-year estimates (tables B01003, B25035, B25077, B25003): https://www.census.gov/programs-surveys/acs/data/summary-file.html
- U.S. Census Bureau 2024 Gazetteer Files (counties): https://www.census.gov/geographies/reference-files/time-series/geo/gazetteer-files.html
- Water Quality Portal: https://www.waterqualitydata.us/
- County data as JSON (CC BY 4.0): https://privatewell.org/data/counties/53001.json
- Page: https://privatewell.org/states/washington/adams-county/

Cite as: PrivateWell (2026). Private well statistics for Adams County, Washington. https://privatewell.org/states/washington/adams-county/ (accessed 19 November 2026).
