How Fulton County stands out in Indiana
- One of the most uniform well-depth patterns in Indiana: the middle half spans 64 ft to 100 ft.
- Its deepest wells go less far than in most of Indiana: the deepest 10% start at 132 ft, 13th shallowest of 91.
- Older housing than most of Indiana: the median home was built in 1966, the 21st oldest of 91 counties.
Closest look-alike: Kosciusko County next door. Compared with it, Fulton County has fewer people estimated on high-arsenic wells (469 vs 8,677), homes 13 years older by median year built and median home values $59,500 lower.
Closest match further away: Delaware County elsewhere in Indiana. Next to it, Fulton County has fewer people estimated on high-arsenic wells (469 vs 4,068), higher yields (35 vs 20 gpm) and median home values $17,100 higher.
Shallow wells in Fulton County
| Household well records | 3,739 |
|---|---|
| Median depth | 80 ft |
| Middle half of wells | 64 ft to 100 ft |
| Shallowest 10% / deepest 10% | under 51 ft / over 132 ft |
| Median static water level | 18 ft |
| Median tested yield | 35 gpm |
| Rank in Indiana (deepest = 1) | 64th of 91 |
| Deeper than this share of US counties in our data | 15% |
Most wells with a recorded depth fall under 100 ft (74%).
Between the median water level and the median depth sit about 62 ft of water, roughly 91 gallons in a 6-inch casing.
Wells here are productive, with a median tested yield of 35 gallons per minute, more than in about 91% of Indiana counties.
Fulton County and the Silurian-Devonian aquifers
All or nearly all of Fulton County sits over the Silurian-Devonian aquifers (carbonate-rock aquifers), the uppermost principal aquifer USGS maps here. Among the 130 counties in our data that sit mainly over the same aquifer (across 7 states), Fulton County's median well of 80 ft is shallower than most: deeper than about 22% of them.
Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.
New wells in Fulton County are going deeper
Wells completed since 2010 are somewhat deeper (median 90 ft) than those drilled before 1990 (70 ft). The 1990s were the busiest decade, with 1,110 new household wells on record. Only 4% of dated records are from 2010 or later, so most wells in service are older.
A 80 ft well is cheap to drill
Shallow wells keep drilling costs down. At $25 to $65 a foot (Angi 2026 cost guide), reaching Fulton County's median of 80 ft costs about $2,000 to $5,200 for the hole itself.
That is small next to local house prices: under 3% of the median home value of $156,500 (Census ACS 2020–2024).
With water only 18 ft down, some homes can use a shallow-well jet pump, which lifts water about 25 feet at most; the rest need a submersible. See pump sizing.
Water quality in Fulton County
Public sampling data for Fulton County is thin (fewer than 10 wells with recent results), so the arsenic model below is the best county-level guide.
Arsenic estimate
About 469 people in Fulton County (range 366 to 698) are estimated by USGS to be on household wells above the 10 µg/L arsenic limit, a middling figure for Indiana. That is more than in about 43% of Indiana counties. USGS model estimate.
What to test for in Fulton County
- Coliform bacteria and nitrate every year; 74% of wells here are under 100 ft deep.
- Arsenic: USGS estimates about 469 people here drink from household wells above the 10 µg/L limit.
Fulton County next to its neighbours
5 of 7 neighbouring counties with records drill deeper. Medians nearby run from Starke County (67 ft) to Miami County (118 ft).
| County | Median depth | Water level | Yield | People on high-arsenic wells (est.) |
|---|---|---|---|---|
| Fulton County | 80 ft | 18 ft | 35 gpm | 469 |
| Miami County | 118 ft | 28 ft | 40 gpm | 1,722 |
| Wabash County | 114 ft | 28 ft | 35 gpm | 1,325 |
| Cass County | 103 ft | 26 ft | 40 gpm | 599 |
| Kosciusko County | 85 ft | 18 ft | 40 gpm | 8,677 |
| Marshall County | 81 ft | 24 ft | 30 gpm | 3,160 |
| Pulaski County | 76 ft | 12 ft | 32 gpm | 1,690 |
| Starke County | 67 ft | 10 ft | 30 gpm | 3,737 |
Neighbours: Census county adjacency 2024.
Buying an older home with a well in Fulton County
- The median home in Fulton County was built in 1966. Older homes often have older wells, so ask when the well was drilled and whether the casing, cap and pump have been replaced.
- A well between 64 ft and 100 ft is normal for Fulton County. Much shallower than 64 ft deserves a careful water test.
- A flow test should be routine; county wells are productive, with a median of 35 gallons per minute.
- Book a well inspection as well as a water test; they check different things.
Help in Indiana
For Fulton County well owners: Purdue University Extension, free or low-cost testing, and all Indiana well rules and data.
Questions about wells in Fulton County
How deep are wells in Fulton County, Indiana?
80 ft is the median across 3,739 household well records; the middle half are 64 ft to 100 ft.
How much water does a Fulton County well produce?
The median tested yield is 35 gallons per minute, high for the state.
What aquifer do wells in Fulton County draw from?
All or nearly all of Fulton County sits over the Silurian-Devonian aquifers (carbonate-rock aquifers), the uppermost principal aquifer USGS maps here. Your own well log names the formation your well actually taps.
Are wells in Fulton County deeper than elsewhere in Indiana?
No, they are shallower: Fulton County ranks deeper than about 30% of Indiana counties in our data, and deeper than 15% of US counties we cover.
How far down is the water in Fulton County wells?
Driller logs put the median static water level at 18 ft below ground.
Data for Fulton County
3,739 household well records, dated from the 1950s to the 2010s, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Fulton County as JSON (CC BY 4.0).
