Ask a question
165 ftmedian well depth25th deepest of 57 in NY
2,164household well recordsState well records
10 gpmmedian tested yieldDriller-reported
1,237people est. on high-arsenic wellsUSGS model
At a glance2,164 household well records feed these figures. Iron stands out in measured groundwater: 33% of 21 sampled wells were over the EPA SMCL. Wells here are productive, with a median tested yield of 10 gallons per minute, more than in about 91% of New York counties. Every neighbouring county with records has deeper wells. Clinton County has about 78,493 residents on 1,038 square miles. It borders Essex and Franklin counties, plus 2 counties in Vermont. It lies in northeastern New York. Lakes, rivers and other water cover 7% of the county's area.

How Clinton County stands out in New York

  • Newer housing than most of New York: the median home was built in 1974, the 4th newest of 57 counties.
  • One of the most varied well-depth patterns in New York: the middle half spans 105 ft to 278 ft.
  • Large by area: 1,038 square miles of land, the 15th largest of the 57 New York counties on this site.

Closest look-alike: Franklin County next door. Compared with it, Clinton County has more people estimated on high-arsenic wells (1,237 vs 529), homes 7 years newer by median year built and median home values $35,200 higher.

Closest match further away: Onondaga County elsewhere in New York. Next to it, Clinton County has homes 10 years newer by median year built, fewer people estimated on high-arsenic wells (1,237 vs 1,733) and wells about 5 ft deeper at the median.

Iron is the one to test for in Clinton County

Iron stands out in measured groundwater: 33% of 21 sampled wells were over the EPA SMCL.

SubstanceWells testedOver limitMedianLimit usedYears
Arsenic210%0.27 µg/LEPA MCL2004 to 2019
Nitrate (as N)210%0.063 mg/L as NEPA MCL2004 to 2019
Uranium210%0.41 µg/LEPA MCL2004 to 2019
Manganese215%0.015 mg/LEPA lifetime health advisory2004 to 2019
Iron2133%0.164 mg/LEPA SMCL2004 to 2019
Fluoride210%0.1 mg/LEPA MCL2004 to 2019
Lead210%0.1 µg/LEPA action level2004 to 2019
Radon2114%320 pCi/LEPA AMCL2004 to 2019
Hardness21no data158 mg/L as CaCO3over 180 mg/L is very hard2004 to 2019

Latest result per well since 1990, Water Quality Portal; 189 results across 9 substances.

Arsenic estimate

About 1,237 people in Clinton County (range 950 to 1,624) are estimated by USGS to be on household wells above the 10 µg/L arsenic limit, a middling figure for New York. That is more than in about 71% of New York counties. USGS model estimate.

What to test for in Clinton County

  • Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
  • Arsenic: USGS estimates about 1,237 people here drink from household wells above the 10 µg/L limit.
  • Iron: 33% of sampled wells here were over the EPA SMCL.
  • Radon: 14% of sampled wells here were over the EPA AMCL.
  • Hardness if you are thinking about a softener (sampled median 158 mg/L).

Got results already? Check them with our result interpreter.

Clinton County has shallower wells than every neighbour

Essex County: median depth 345 ftFranklin County: median depth 180 ftChittenden County, VT: median depth 323 ftGrand Isle County, VT: median depth 240 ftClinton County: median depth 165 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
Clinton County (orange outline) is the palest county on this map; every neighbour with records drills deeper.

All 4 neighbours with records have deeper median wells, from Franklin County (180 ft) to Essex County (345 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
Clinton County165 ftno data10 gpm1,237
Essex County345 ftno data7 gpm88
Chittenden County, VT323 ft25 ft6 gpm578
Grand Isle County, VT240 ft16 ft6 gpm36
Franklin County180 ftno data10 gpm529

Neighbours: Census county adjacency 2024.

How deep wells go in Clinton County

groundmiddle half of wells: 105 ft–278 ftmedian well 165 ftdeepest 10% start at 400 ft
To scale: the median Clinton County household well bottoms out at 165 ft, and the deepest tenth go past 400 ft.
Household well records2,164
Median depth165 ft
Middle half of wells105 ft to 278 ft
Shallowest 10% / deepest 10%under 75 ft / over 400 ft
Median tested yield10 gpm
Rank in New York (deepest = 1)25th of 57
Deeper than this share of US counties in our data57%

Most wells with a recorded depth fall 100 to 300 ft (56%). Only 5% reach 500 ft or more.

Wells here are productive, with a median tested yield of 10 gallons per minute, more than in about 91% of New York counties.

What drilling to 165 ft costs in Clinton County

Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 165 ft runs about $4,100 to $10,700. At the 75th percentile (278 ft) it is $7,000 to $18,100.

Against a median home value of $180,600 (Census ACS 2020–2024), a new well at that depth is about 2% to 6% of a house's worth, before equipment.

Equipment and permits come on top; our guide to drilling quotes shows what to ask New York drillers to itemize.

Clinton County and the New York sandstone aquifers

About 46% of Clinton County is over the New York sandstone aquifers (sandstone aquifers), with 41% over rock outside any principal aquifer.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

Buying a home with a well in Clinton County

  • The median home here was built in 1974. Ask the seller for the well log, or look it up in the state well records.
  • A well between 105 ft and 278 ft is normal for Clinton County. Much shallower than 105 ft deserves a careful water test.
  • A flow test should be routine; county wells are productive, with a median of 10 gallons per minute.
  • Make sure the water test includes iron; 33% of sampled local wells were over its limit.

Help in New York

For Clinton County well owners: New York State Department of Health, certified labs in New York, free or low-cost testing, and all New York well rules and data.

Questions about wells in Clinton County

What is the average well depth in Clinton County, New York?

The median is 165 ft across 2,164 records, but depths vary a lot: the middle half run from 105 ft to 278 ft.

Is well water safe to drink in Clinton County?

Iron stands out in measured groundwater: 33% of 21 sampled wells were over the EPA SMCL. Arsenic is the main known risk, with about 1,237 people estimated on high-arsenic wells.

What aquifer do wells in Clinton County draw from?

About 46% of Clinton County is over the New York sandstone aquifers (sandstone aquifers), with 41% over rock outside any principal aquifer. Your own well log names the formation your well actually taps.

How much water does a Clinton County well produce?

The median tested yield is 10 gallons per minute, high for the state.

What would a new well in Clinton County cost to drill?

Roughly $4,100 to $10,700 for the drilling at the median depth of 165 ft, before the pump and pressure tank.

Data for Clinton County

2,164 household well records, from the state well records (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Clinton County as JSON (CC BY 4.0).

Questions about a well in Clinton County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program