Ask a question
300 ftmedian well depth1st deepest of 39 in WA
813household well recordsState well records
50 gpmmedian tested yieldDriller-reported
84 ftmedian water levelDriller-reported
At a glanceThe county has 813 household well records on file, enough for stable medians. Wells here are productive, with a median tested yield of 50 gallons per minute, more than in about 95% of Washington counties. About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Static water levels are among the deeper ones in the state, with a median of 84 ft below ground. Adams County has about 20,800 residents on 1,925 square miles. Its 42 household well records per 100 square miles are among the sparsest in the state. It borders Franklin, Grant, Lincoln and Whitman counties. It lies in eastern Washington.

How Adams County stands out in Washington

  • Very little surface water: lakes and rivers cover under 1% of the county, one of the lowest shares in Washington.
  • Its deepest wells go further than in most of Washington: the deepest 10% start at 1,226 ft, 1st deepest of 39.
  • Lower-priced homes: a median owner-occupied value of $273,300, 3rd lowest among 39 Washington counties here.
  • Wells are spread thin: 42 household well records per 100 square miles, 4th sparsest in Washington.

Closest look-alike: Whitman County next door. Compared with it, Adams County has more people estimated on high-arsenic wells (632 vs 186), water standing 24 ft further down and wells about 80 ft deeper at the median.

Closest match further away: Columbia County elsewhere in Washington. Next to it, Adams County has more people estimated on high-arsenic wells (632 vs 24), homes 24 years newer by median year built and water standing 34 ft further down.

Deep wells in Adams County

groundmiddle half of wells: 190 ft–533 ftwater level 84 ftmedian well 300 ftdeepest 10% start at 1,226 ft
To scale: ground, the median water level at 84 ft and the median well bottom at 300 ft in Adams County.
Household well records813
Median depth300 ft
Middle half of wells190 ft to 533 ft
Shallowest 10% / deepest 10%under 140 ft / over 1,226 ft
Median static water level84 ft
Median tested yield50 gpm
Rank in Washington (deepest = 1)1st of 39
Deeper than this share of US counties in our data87%

The largest group of wells with a recorded depth fall 100 to 300 ft (44%).

A typical well here holds a deep column of water, about 216 ft, or 318 gallons in a 6-inch casing. That reserve covers short bursts of heavy use while the aquifer refills the well.

Wells here are productive, with a median tested yield of 50 gallons per minute, more than in about 95% of Washington counties.

Adams County and the Columbia Plateau basin-fill aquifers

About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Among the 6 counties in our data that sit mainly over the same aquifer, Adams County's median well of 300 ft is deeper than most: deeper than about 100% of them.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

Deep wells make drilling in Adams County expensive

At 300 ft for a median well, depth drives the bill: $25 to $65 a foot (Angi 2026 cost guide) puts drilling alone at $7,500 to $19,500. A well as deep as the 75th percentile (533 ft) would be $13,300 to $34,600.

Against a median home value of $273,300 (Census ACS 2020–2024), a new well at that depth is about 3% to 7% of a house's worth, before equipment.

With a typical water level of 84 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

Adams County has deeper wells than every neighbour

Franklin County: median depth 203 ftGrant County: median depth 180 ftLincoln County: median depth 230 ftWhitman County: median depth 220 ftAdams County: median depth 300 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
Adams County (orange outline) is the darkest shape here: deeper median wells than any neighbour.

None of its 4 neighbours with records has a deeper median well. The neighbours range from Grant County (180 ft) to Lincoln County (230 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
Adams County300 ft84 ft50 gpm632
Lincoln County230 ft71 ft28 gpm163
Whitman County220 ft60 ft50 gpm186
Franklin County203 ft100 ft112 gpm3,212
Grant County180 ft65 ft40 gpm4,097

Neighbours: Census county adjacency 2024.

Arsenic is the one to test for in Adams County

In measured groundwater samples, arsenic was the most common problem, with 10% of 10 tested wells over the EPA MCL.

SubstanceWells testedOver limitMedianLimit usedYears
Arsenic1010%3.9 µg/LEPA MCL2002 to 2023
Nitrate (as N)128%4.14 mg/L as NEPA MCL1994 to 2016
Uranium100%5.895 µg/LEPA MCL2002 to 2023
Manganese120%0.0002 mg/LEPA lifetime health advisory1994 to 2023
Iron120%0.0045 mg/LEPA SMCL1994 to 2023
Fluoride120%0.555 mg/LEPA MCL1994 to 2023
Lead100%0.0445 µg/LEPA action level2002 to 2023
Radon120%340 pCi/LEPA AMCL1994 to 2016
Hardness12no data227.5 mg/L as CaCO3over 180 mg/L is very hard1994 to 2023

Latest result per well since 1990, Water Quality Portal; 102 results across 9 substances.

Arsenic estimate

About 632 people in Adams County (range 524 to 758) are estimated by USGS to be on household wells above the 10 µg/L arsenic limit, a middling figure for Washington. That is more than in about 51% of Washington counties. USGS model estimate.

What to test for in Adams County

  • Coliform bacteria and nitrate every year even in wells this deep (300 ft median); bacteria get in through a cracked cap or casing, not only through the aquifer.
  • Arsenic: USGS estimates about 632 people here drink from household wells above the 10 µg/L limit.
  • Hardness if you are thinking about a softener (sampled median 228 mg/L).

Got results already? Check them with our result interpreter.

Drilling over the decades in Adams County

1990s395 ft2000s280 ft2010s286 ft2020s280 ft

Much of the drilling is recent: the busiest decade was the 2010s, with 242 household wells logged. 49% of dated records are from 2010 or later, a sign of steady new drilling.

Buying a home with a well in Adams County

  • The median home here was built in 1977. Ask the seller for the well log, or look it up in Well Construction Reports (Well Log Database), Washington Department of Ecology.
  • Wells here commonly run 190 ft to 533 ft. If the log shows a much shallower well, ask the inspector why.
  • A flow test should be routine; county wells are productive, with a median of 50 gallons per minute.
  • Make sure the water test includes arsenic; 10% of sampled local wells were over its limit.

Help in Washington

For Adams County well owners: Washington State Department of Health and Department of Ecology, certified labs in Washington, free or low-cost testing, and all Washington well rules and data.

Questions about wells in Adams County

How deep do you have to drill for water in Adams County, Washington?

The median is 300 ft across 813 records, but depths vary a lot: the middle half run from 190 ft to 533 ft.

Are wells in Adams County deeper than elsewhere in Washington?

Yes: Adams County ranks deeper than about 100% of Washington counties in our data, and deeper than 87% of US counties we cover.

What aquifer do wells in Adams County draw from?

About 59% of Adams County is over the Columbia Plateau basin-fill aquifers (unconsolidated sand and gravel aquifers), with 41% over the Columbia Plateau basaltic-rock aquifers. Your own well log names the formation your well actually taps.

How much water does a Adams County well produce?

The median tested yield is 50 gallons per minute, high for the state.

How far down is the water in Adams County wells?

Driller logs put the median static water level at 84 ft below ground.

Data for Adams County

813 household well records, dated from the 1990s to the 2020s, from Well Construction Reports (Well Log Database), Washington Department of Ecology (source); homes and population from Census ACS 2020–2024. How we filter the records. Download Adams County as JSON (CC BY 4.0).

Questions about a well in Adams County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program