Ask a question
142 ftmedian well depth27th deepest of 39 in WA
4,753household well recordsState well records
30 gpmmedian tested yieldDriller-reported
1,031people est. on high-arsenic wellsUSGS model
At a glanceBehind these numbers are 4,753 household wells logged by drillers. About 52% of King County is over the Puget Sound aquifer system (unconsolidated sand and gravel aquifers), with 46% over rock outside any principal aquifer. In measured groundwater samples, arsenic was the most common problem, with 18% of 153 tested wells over the EPA MCL. The median tested yield is 30 gallons per minute. With about 2,287,171 residents, King County is densely settled at roughly 1,081 people per square mile. It borders Chelan, Kitsap, Kittitas, Pierce, Snohomish and Yakima counties. It lies in western Washington. Lakes, rivers and other water cover 8% of the county's area.

How King County stands out in Washington

  • Higher-priced homes: a median owner-occupied value of $859,900, 1st highest among 39 Washington counties here.
  • The most populous counties we cover in Washington, with about 2,287,171 residents.
  • A low share of owner-occupied homes (55%), 2nd lowest in our Washington set.

Closest look-alike: Pierce County next door. Compared with it, King County has fewer people estimated on high-arsenic wells (1,031 vs 1,738), median home values $333,300 higher and lower yields (30 vs 38 gpm).

Closest match further away: Benton County elsewhere in Washington. Next to it, King County has fewer people estimated on high-arsenic wells (1,031 vs 5,218), median home values $452,100 higher and homes 5 years older by median year built.

Wells in King County are shallower than most of Washington

groundmiddle half of wells: 88 ft–238 ftwater level 51 ftmedian well 142 ftdeepest 10% start at 346 ft
To scale: ground, the median water level at 51 ft and the median well bottom at 142 ft in King County.
Household well records4,753
Median depth142 ft
Middle half of wells88 ft to 238 ft
Shallowest 10% / deepest 10%under 51 ft / over 346 ft
Median static water level51 ft
Median tested yield30 gpm
Rank in Washington (deepest = 1)27th of 39
Deeper than this share of US counties in our data47%

Most wells with a recorded depth fall 100 to 300 ft (53%). Only 3% reach 500 ft or more.

Between the median water level and the median depth sit about 91 ft of water, roughly 134 gallons in a 6-inch casing.

The median tested yield is 30 gallons per minute.

Arsenic is the one to test for in King County

In measured groundwater samples, arsenic was the most common problem, with 18% of 153 tested wells over the EPA MCL.

SubstanceWells testedOver limitMedianLimit usedYears
Arsenic15318%2 µg/LEPA MCL1991 to 2017
Nitrate (as N)1600%0.05 mg/L as NEPA MCL1991 to 2017
Manganese13511%0.026 mg/LEPA lifetime health advisory1991 to 2017
Iron13517%0.032 mg/LEPA SMCL1991 to 2017
Fluoride1430%0.0764 mg/LEPA MCL1991 to 2017
Lead1430%0.5 µg/LEPA action level1991 to 2017
Radon210%250 pCi/LEPA AMCL1991 to 1996
Hardness125no data61 mg/L as CaCO3over 180 mg/L is very hard1991 to 2017

Latest result per well since 1990, Water Quality Portal; 1,015 results across 8 substances.

Arsenic estimate

About 1,031 people in King County (range 739 to 1,392) are estimated by USGS to be on household wells above the 10 µg/L arsenic limit, a middling figure for Washington. That is more than in about 69% of Washington counties. USGS model estimate.

What to test for in King County

  • Coliform bacteria and nitrate once a year, the EPA baseline for any private well.
  • Arsenic: USGS estimates about 1,031 people here drink from household wells above the 10 µg/L limit.
  • Iron: 17% of sampled wells here were over the EPA SMCL.
  • Manganese: 11% of sampled wells here were over the EPA lifetime health advisory.

Got results already? Check them with our result interpreter.

King County and the Puget Sound aquifer system

About 52% of King County is over the Puget Sound aquifer system (unconsolidated sand and gravel aquifers), with 46% over rock outside any principal aquifer. Among the 8 counties in our data that sit mainly over the same aquifer, King County's median well of 142 ft is near the middle: deeper than about 62% of them.

Uppermost principal aquifer: USGS Principal Aquifers map, sampled across the county on a grid. A well can draw from a deeper or local aquifer instead.

What drilling to 142 ft costs in King County

Using $25 to $65 per foot for drilling only (Angi 2026 cost guide), a well at the median depth of 142 ft runs about $3,600 to $9,200. At the 75th percentile (238 ft) it is $6,000 to $15,500.

That is small next to local house prices: under 1% of the median home value of $859,900 (Census ACS 2020–2024).

With a typical water level of 51 ft, homes here use either a deep-well jet pump or a submersible, depending on yield. Price the pump separately from drilling.

King County next to its neighbours

Chelan County: median depth 155 ftKitsap County: median depth 146 ftKittitas County: median depth 210 ftPierce County: median depth 128 ftSnohomish County: median depth 105 ftYakima County: median depth 185 ftKing County: median depth 142 ft<50 ft50-100 ft100-200 ft200-300 ft300-500 ft500+ ft
King County (orange outline) with 6 neighbouring counties; darker means deeper median wells.

4 of 6 neighbouring counties with records drill deeper. Medians nearby run from Snohomish County (105 ft) to Kittitas County (210 ft).

CountyMedian depthWater levelYieldPeople on high-arsenic wells (est.)
King County142 ft51 ft30 gpm1,031
Kittitas County210 ft60 ft40 gpm841
Yakima County185 ft64 ft60 gpm6,940
Chelan County155 ft49 ft4 gpm656
Kitsap County146 ft57 ft17 gpm1,374
Pierce County128 ft54 ft38 gpm1,738
Snohomish County105 ft32 ft20 gpm6,178

Neighbours: Census county adjacency 2024.

Drilling over the decades in King County

1990s137 ft2000s148 ft2010s136 ft2020s155 ft

Much of the drilling is recent: the busiest decade was the 2000s, with 1,864 household wells logged.

Buying or renting a home with a well in King County

  • The median home here was built in 1983. Ask the seller for the well log, or look it up in Well Construction Reports (Well Log Database), Washington Department of Ecology.
  • A well between 88 ft and 238 ft is normal for King County. Much shallower than 88 ft deserves a careful water test.
  • A flow test should be routine; county wells are productive, with a median of 30 gallons per minute.
  • Make sure the water test includes arsenic; 18% of sampled local wells were over its limit.
  • 55% of occupied homes in King County are owner-occupied (Census ACS 2020–2024). Rentals are common, so if you rent, ask the landlord for recent well test results.

Help in Washington

For King County well owners: Washington State Department of Health and Department of Ecology, certified labs in Washington, free or low-cost testing, and all Washington well rules and data.

Questions about wells in King County

What is the average well depth in King County, Washington?

The median is 142 ft across 4,753 records, but depths vary a lot: the middle half run from 88 ft to 238 ft.

Is well water safe to drink in King County?

In measured groundwater samples, arsenic was the most common problem, with 18% of 153 tested wells over the EPA MCL. Arsenic is the main known risk, with about 1,031 people estimated on high-arsenic wells.

What aquifer do wells in King County draw from?

About 52% of King County is over the Puget Sound aquifer system (unconsolidated sand and gravel aquifers), with 46% over rock outside any principal aquifer. Your own well log names the formation your well actually taps.

How much water does a King County well produce?

The median tested yield is 30 gallons per minute.

Are wells in King County deeper than elsewhere in Washington?

No, they are shallower: King County ranks deeper than about 31% of Washington counties in our data, and deeper than 47% of US counties we cover.

Data for King County

4,753 household well records, dated from the 1990s to the 2020s, from Well Construction Reports (Well Log Database), Washington Department of Ecology (source); homes and population from Census ACS 2020–2024. How we filter the records. Download King County as JSON (CC BY 4.0).

Questions about a well in King County?

Ask us about your situation. A real person reads every question.

This field is required.
We reply by email. We never share it without your permission.Enter an email address like name@example.com.
Describe what you are seeing and anything you have tried. Plain words are fine.Please write at least 20 characters so we can help.
Choose your state so we can point you to the right rules.
Prefer the full form?

Thanks, we have your question.

We read every message and reply by email, usually within a few working days. If it is urgent (sickness, a positive E. coli test, or a flooded well), use bottled water and call your county or state health department now.

Find your state's well program